Instructions

Installation guide - mural & wallpaper

Required materials

Dry, clean cloth
Level
Measuring tape
Spatula (included)
Exacto-type knife
Painter's tape

Suitable surfaces

Smooth, dry and clean surface, covered with a primer and one or two coats of paint.

Please wait a minimum of 15 days before installing on a freshly painted surface.

Surfaces to avoid

Dirty, moldy or dusty surface

Textured, damaged or peeling surface

*It is not recommended to install directly onto brick, wood, gypsum, primer or plaster

Watch our installation video

Watch the video

Prepare the surface

Turn off the power to the electrical outlets on the surface to be covered and remove the plates with
precaution.

Remove any objects hanging on the wall that could be an obstacle during installation.

Sand, fill or repair imperfections to make the surface completely smooth.

Wash the wall with a dry cloth (without cleaning products) to make it clean and free of
dust and residue.

The surface must be smooth, clean and completely dry before starting the installation.

Check the numbering and connections

Lay the rolls on the floor, printed side up, in numerical order (from
(left to right).

Check that there are no printing defects, that the total width is correct and that the joins follow each other from one panel to the next (more on the joins in the following sections).

In the event of a manufacturing defect or error in your order, please
Contact us before installing the vinyl.

Attach the first panel

Secure the first panel temporarily with adhesive tape, starting from the left and the top of the wall.

Using a level or laser, ensure the first panel is straight by referring to the right vertical edge. Do not rely on the walls and ceilings; they are not always level.

Peel back at least 6 inches of the white backing film, cut it, then attach the adhesive vinyl.
pressing firmly with the application spatula while making downward movements.

Peel off the remaining backing film, one section at a time, and gradually stick the vinyl to the wall with the spatula, making sure the panel remains level.

Install the following panels

Temporarily fix the panel to the wall with adhesive tape, using the previous panel as a guide to align the pattern.

Overlap the left vertical connector of the panel to be fixed onto the right vertical connector of the panel
previous.

It is crucial to check that the joints, also called overlaps, are properly aligned from one panel to the next.
the other. The overlaps must overlap by 0.5 inches, no more, no less.

At this stage, you will no longer need your level, only your eye to do it well
align each element of the pattern.

Correct yourself if necessary by gently peeling off the vinyl to realign yourself.

Hand cutting away excess self-adhesive mural

Finishing

If bubbles form, slide them towards the edges using the spatula or your hands.
It is also possible to pierce them with a needle by smoothing them with your fingers.

Press the joints firmly where there is excess vinyl and cut it with the excato.

Cut around the electrical outlets and then reinstall the plates, making sure that the
The power is still off.