Installation instructions
Before you begin installing large stickers, make sure to clean the surface where you'll be applying them. Use isopropyl alcohol to remove any dirt or residue that might prevent the stickers from adhering properly. Dry the surface thoroughly before you start.
Applying the stickers
For large stickers, it is recommended to start by aligning the top of the sticker with the surface. Use a plastic squeegee to smooth the sticker gradually, removing any air bubbles as you go. Continue this process until the sticker is completely adhered to the surface.
Finishing and maintenance
Once the large sticker is perfectly applied, use a soft cloth to smooth out any imperfections and ensure good adhesion. To care for the sticker, avoid harsh chemicals and do not use abrasive cleaners. Large stickers can add a unique touch to your space, so take good care of them to enjoy them for a long time.
Required materials
Dry, clean cloth
Painter's tape
Chisel
Suitable surfaces
Smooth, dry and clean surface, covered with a primer and one or two coats of paint.
Please wait a minimum of 15 days before installing on a freshly painted surface.
Surfaces to avoid
Dirty, moldy or dusty surface
Textured, damaged or peeling surface
*It is not recommended to install directly onto brick, wood, gypsum, primer or plaster
Watch our installation video
Watch the video
1. Prepare the surface
The surface must be completely smooth, clean, and dry. Remove any dust with a slightly damp cloth. Ensure there are no residues on the wall, such as paint drips. Sanded surfaces must be flawless, as imperfections may be visible. If the paint is fresh, wait at least two weeks before installation.
2. Prepare the installation
It is preferable to proceed in steps 2.
Place the sticker on the wall with painter's tape to visualize where the sticker will be located.
3. Stick the top of the sticker
Once the sticker is in its final position, peel back about 2 inches of the backing and cut it out. Then, stick this part to the wall by pressing and sliding it with your hands. Once the top of the sticker is firmly attached to the wall, you can remove the backing.
4. Remove the backing film
Gradually peel off the backing film while sliding your hands over the sticker to adhere it to the wall. Carefully smooth out any air bubbles by sliding them outwards.
5. Remove air bubbles
If air bubbles are still present, try to slide them outwards. Otherwise, use a needle to pierce them.
View or download our PDF
See the PDFDo you have any questions?
Contact us easily. We will be happy to answer all your questions.
Via Facebook chat
Visit our Facebook page or use the chat at the bottom of the page.
By phone
